Thursday, 8 June 2017

Task 5 - Final bug

This is my final sculpture, I chose to sculpt the design I made on task two of a preying mantis, tarantula, scorpion. Below are screenshots of said sculpture.

To begin the project I got the 3D sphere I created out of wire and wrapped paper mache around it using multiple layers until I got a big enough back body size and squishing it to make the top and bottom more flat. I did the same again but with less layers for the second part of the body. Then I wrapped both parts in ModRoc.

After that I got some straws and wire and placed the wire inside of the straws, I then started to bend them into the same shape that a tarantulas legs would go eventually encasing them in ModRoc. I used straws since they are much thicks than wire, but the wire allowed the straws to stay in the same shape with unfolding.


Next I created the head and neck using corrugated card. I firstly started with the neck, cutting off a piece and rolling it up then using gummed paper to stick the two sides together. Then I encased that in ModRoc. For the head I cut out two connected pieces of equilateral triangles and folded the edges over so I had two equal bases mirroring each other with a flat rectangular piece connecting them that resembled a mantis mouth. I then encased that in ModRoc and stuck the two pieces together.


The eyes and antenna were next connected to the head. Firstly, I rolled up the eyes using newspaper and paper mache adding a few layers on both. Encasing it in ModRoc and connected them to the head, I then got one wire piece and bent it into an antenna looking state using more ModRoc connecting it to the head.

Finally, I created the scorpion arms by rolling up 4 paper mache balls each one being a size bigger than the other to show it growing. The first three balls were connected using ModRoc which was pressed in between each ball to resemble that of a scorpion arm. The final ball had more ModRoc placed on the end and pinch to resemble a point that looks like one on a scorpion, it was connected to the final ball and then connected to the mantis body. The same method was done for the other arms.


This is the final picture of what my sculpture looks like.


No comments:

Post a Comment